Satec PM130 PLUS Series - Page 11

PM130 PLUS Powermeter Series_Installation Operation and Manual 11
CT wiring
To connect an Option module:
1. Assemble the module on the meter.
2. Power the PM130 PLUS unit on.
Assembling a module
To operate the PM130 PLUS:
1. Perform device diagnostics.
2. Configure the device through the PM130 PLUS unit front panel display.
Configuring the PM130 PLUS remotely
1. Install the PAS application software on your PC.
2. Configure the PAS database for your meter.
3. Configure the PAS communications settings.
4. Upgrade the meter firmware if a new version is available.
5. Set up the meter using the PAS application software.
6. Configure your security settings through the meter security setup.
7. Configure your communication protocol settings.
8. Configure Billing/TOU registers.
At this stage, the PM130 PLUS should be ready for operation.
Designations used throughout the manual:
E - available in the PM130E
EH - available in the PM130EH