Satec PM130 PLUS Series - Configuring DNP3

Chapter 5 Configuring the PM130 PLUS Configuring Communication Protocols
PM130 PLUS Powermeter Series_Installation Operation and Manual 116
5.6.2 Configuring DNP3
Refer to the PM130 DNP3 Reference guide for information on the DNP3 protocol implementation and a
list of the available data points.
DNP Options
Select Protocol Setup from the Meter Setup menu and click on the DNP Options tab.
Figure 5-21: Protocol Setup Dialog Box – DNP Options Tab
The following table describes available options. Refer to the DNP3 Data Object Library document available
from the DNP User’s Group on the DNP3 object types.
Table 30: DNP Options
Parameter
Options
Default
Description
Binary Inputs (BI)
Binary Input Object
Single-bit
With Status
Single-bit
The default BI object variation for requests with qualifier
code 06 when no specific variation is requested
Analog Inputs (AI)
Analog Input Object
32-bit
32-bit–Flag
16-bit
16-bit–Flag
16-bit-Flag
The default AI object variation for requests with qualifier
code 06 when no specific variation is requested
Binary Counters (BC)
Binary Counter
Object
32-bit+Flag
32-bit–Flag
16-bit+Flag
16-bit–Flag
32-bit-Flag
The default BC object variation for requests with qualifier
code 06 when no specific variation is requested