Satec PM130 PLUS Series - Page 120

Chapter 6 Device Control and Upgrading Resetting Accumulators, Maximum Values and Files
PM130 PLUS Powermeter Series_Installation Operation and Manual 120
Using PAS
Ensure that the On-line button on the PAS toolbar is checked, and then select Reset from the Monitor
menu.
Figure 6-1: Reset Dialog
To reset the desired values or files:
1. Click on the corresponding button, and then confirm your command.
2. If an entry has more than one target, you are allowed to select targets to reset.
3. Check the corresponding boxes, and then click OK.
Figure 6-2: Reset Maximum Demands Dialog Box