Chapter 6 Device Control and Upgrading Updating the Meter Clock
PM130 PLUS Powermeter Series_Installation Operation and Manual 121
6.2 Updating the Meter Clock
Using the Front Display
Select the rtc entry from the main menu.
To change the time or date:
1. Use the UP and DOWN arrow buttons to select a setup option
2. Highlight an item you want to change by pressing briefly the SELECT button.
3. When you access the time setup display, the hours and minutes are frozen allowing you to adjust
the time.
4. Adjust the selected item with the UP and DOWN arrow buttons.
5. Highlight the next item to change and adjust it in the same manner.
6. Press ENTER to confirm your changes or press ESC to leave the clock settings unchanged.
7. If you confirm the time change while the seconds are highlighted, the seconds are zeroed;
otherwise they stay unchanged.
8. Press ESC to exit the menu.
Table 32 describes available options.
Table 32: Clock Setup Options
The time is displayed as hh.mm.ss, where the hours and minutes are
shown in the middle window separated by a dot, and the seconds - in
the lower window.
The date is displayed as per the user definition, where the first two items
are shown in the middle window, and the last one - in the lower window.
See Configuring the Display for instructions on how to select the date
format.
Using PAS
Ensure that the On-line button on the PAS toolbar is checked, and then select RTC from the Monitor
menu or click on the Real-Time Clock button on the PAS toolbar.
The RTC dialog box displays the current PC time and the time in your meter.
Figure 6-3: Real Time Clock Window
To synchronize the meter clock with the PC clock, click Set.
To Next Page
Loading...
