Chapter 6 Device Control and Upgrading Remote Relay Control
PM130 PLUS Powermeter Series_Installation Operation and Manual 124
6.5 Remote Relay Control
You can use PAS to send a remote command to your meter to operate any relay output or release a
latched relay, except of the relays linked to an internal pulse source. These relays are blocked for operating
from outside of the meter.
To access the relay control dialog, ensure that the On-line button on the PAS toolbar is checked, select
Device Control from the Monitor menu, and then click on the Remote Relay Control tab.
Figure 6-6: Device Control Dialog Box – Remote Relay Control Tab
To send a remote command to a relay:
1. Select a desired command in the Relay Command box for a relay:
2. OPERATE – to operate a relay
3. RELEASE – to remove your remote command, or to release a latched relay
4. Click Send.
To Next Page
Loading...
