Chapter 7 Monitoring Meters Viewing Real-time Data
PM130 PLUS Powermeter Series_Installation Operation and Manual 128
7.1.2 Organizing Data Sets
PAS supports 33 programmable data sets with up to 40 data parameters. Set #0 is intended for simple
meters, which have a limited number of parameters, and is not recommended for the use with the PM130
PLUS. To re-organize data sets, select RT Data Sets from the Monitor menu or click on the button on
the local toolbar.
Some data sets are preset for your convenience and others are empty. You can freely modify data sets.
See Appendix D for a list of data available in your meter.
7.1.3 Polling Options
To change the polling options, click on the Data Monitor window with the right mouse button and select
Options. If you check Do not stop on errors, polling is resumed automatically when a communication
error occurs, otherwise polling stops until you restart it manually.
7.1.4 Viewing a Data Table
Changing the Data View
PAS displays data in either a single record or multi-record view. To change the view, click on the Data
Monitor window with the right mouse button and select either Wrap to see a single record, or UnWrap to
go to the multi-record view.
Adjusting the Number of Rows in a Multi-Record View
Click the window with the right mouse button, select Options, adjust the number of records you want to
see in the window, and then click OK. When the number of retrieved records exceeds the number of rows
in the window, the window scrolls up so that older records are erased.
See Working with Tables in Chapter 9 for more information on working with tables.
To Next Page
Loading...
