Satec PM130 PLUS Series - Available Options; Digital I;O; Analog Output

Chapter 1 General Information Available Options
PM130 PLUS Powermeter Series_Installation Operation and Manual 15
1.2 Available Options
The PM130 PLUS can be provided with an optional expansion module from the following list:
• Digital I/O
• Analog outputs
• TOU - Battery-operated clock unit
• Ethernet communication port
• Profibus DP communication port
• RS-232/RS-422/RS-485 communication port
• GPRS communication port
1.2.1 Digital I/O
The PM130 PLUS digital I/O expansion module provides:
4DI/2DO module
• 4 dry contact digital inputs (DI) for monitoring external contacts and receiving pulses from energy,
water, and gas meters
• Programmable de-bounce time; 1-ms scan time.
• 2 electro-mechanical or solid-state relay outputs (RO) for alarms and controls, and for output
energy pulses; unlatched, latched and pulse operations, failsafe operation for alarm notifications;
programmable pulse width; direct remote relay control through communications; 1-cycle update
time.
8DI module
• 8 dry contact digital inputs (DI) for monitoring external contacts and receiving pulses from energy,
water, and gas meters
• Programmable de-bounce time; 1-ms scan time.
12DI/4DO module
• 12 dry contact digital inputs (DI) for monitoring external contacts and receiving pulses from
energy, water, and gas meters
• Programmable de-bounce time; 1-ms scan time.
• 4 electro-mechanical relay outputs (RO) for alarms and controls, and for output energy pulses;
unlatched, latched and pulse operations, failsafe operation for alarm notifications; programmable
pulse width; direct remote relay control through communications; 1-cycle update time.
1.2.2 Analog Output
The PM130 PLUS analog output (AO) expansion module provides:
• 4 optically isolated analog outputs with an internal power supply;
• Options for 0-20mA, 4-20mA, 0-1mA, and  1mA output; 1-cycle update time.