Satec PM130 PLUS Series - Appendix C Setpoint Triggers and Actions

Appendix C Setpoint Triggers and Actions
PM130 PLUS Powermeter Series_Installation Operation and Manual 156
Appendix C Setpoint Triggers and Actions
Table 35: Setpoint Triggers
Display Code
Designation
Description
nonE
NONE
None (condition is not active)
Status Inputs
S1.On
STAT INP #1 ON
Status input #1 ON
S2.On
STAT INP #2 ON
Status input #2 ON
S3.On
STAT INP #3 ON
Status input #3 ON
S4.On
STAT INP #4 ON
Status input #4 ON
S1.OFF
STAT INP #1 OFF
Status input #1 OFF
S2.OFF
STAT INP #2 OFF
Status input #2 OFF
S3.OFF
STAT INP #3 OFF
Status input #3 OFF
S4.OFF
STAT INP #4 OFF
Status input #4 OFF
Relays
r1.On
RELAY #1 ON
Relay #1 ON
r2.On
RELAY #2 ON
Relay #2 ON
r1.OFF
RELAY #1 OFF
Relay #1 OFF
r2.OFF
RELAY #2 OFF
Relay #2 OFF
Phase Reversal
POS.P.r
POS PHASE REVERSAL
Positive phase rotation reversal
nEG.P.r
NEG PHASE REVERSAL
Negative phase rotation reversal
Low/High 1-Cycle Values on any Phase
r.Hi. U
HI VOLT RT
1
High voltage
r.Lo. U
LO VOLT RT
1
Low voltage
r.Hi. C
HI AMPS RT
High current
r.Lo. C
LO AMPS RT
Low current
r.thd.U
HI V THD
2
High voltage THD
r.thd.C
HI I THD
2
High current THD
r.HFc.C
HI KF RT
High K-Factor
r.tdd.C
HI I TDD
High current TDD
1-Cycle Auxiliary Values
r.Hi.Fr
HI FREQ RT
High frequency
r.Lo.Fr
LO FREQ RT
Low frequency
r.U.Unb
HI V UNB% RT
1
High voltage unbalance
r.C.Unb
HI I UNB% RT
High current unbalance
1-Sec Phase Values
A.Hi.C1
HI I1 AVR
High I1 current
A.Hi.C2
HI I2 AVR
High I2 current