Chapter 2 Installation Electrical Installation
PM130 PLUS Powermeter Series_Installation Operation and Manual 24
2.4 Electrical Installation
The equipment installation shall conform to the following instructions:
a) a switch or circuit-breaker shall be included in the building installation;
b) It shall be in close proximity to the equipment and within easy reach of the OPERATOR;
c) It shall be marked as the disconnecting device for the equipment.
Before installing, ensure that all incoming power sources are shut OFF. Failure to observe
this practice can result in serious or even fatal injury and damage to equipment.
2.4.1 Typical Installation
Figure 2-6 Typical Installation Diagram
2.4.2 Terminals
Figure 2-7 Terminals - Rear View
To Next Page
Loading...
