Satec PM130 PLUS Series - I;O Connections; 4 DI;2 DO Module

Chapter 2 Installation I/O Connections
PM130 PLUS Powermeter Series_Installation Operation and Manual 37
2.6 I/O Connections
Before I/O Module installation ensure that all incoming power sources are shut OFF. Failure to
observe this practice can result in serious or even fatal injury and damage to equipment.
Figure 2-21 Module Connector Cover – Before Module Assembly
For I/O ratings, see Technical Specifications in Appendix A.
2.6.1 4DI/2DO Module
Figure 2-22 4DI/2DO Module Assembly