Satec PM130 PLUS Series - Navigation Buttons

Chapter 3 Using Front Display Data Display
PM130 PLUS Powermeter Series_Installation Operation and Manual 54
Fundamental Component
The PM130EH can display total displacement power factor and active power for the fundamental
component if it is enabled through the display setup (see Configuring the Display).
When phase power readings are allowed, the PM130EH also displays per-phase displacement power
factor and active power for the fundamental component.
Auto Return
If no buttons are pressed for 30 seconds while the display Auto Return option is enabled, the display
automatically returns to the main screen from any other measurement display.
The Auto Return option can be enabled through the display setup (see Configuring the Display).
Auto Scroll
If no buttons are pressed for 30 seconds while in the common measurements display, and the Auto Scroll
option is enabled in the meter, the display automatically scrolls through all available pages. The scroll
interval can be adjusted through the display setup (see Configuring the Display).
To stop auto scrolling, press briefly the UP or DOWN button.
Brightness
The PM130 display has a 3-level adjustable brightness. It is normally preset at the factory to the highest
level. You can adjust the display through the display setup (see Configuring the Display).
3.2.2 Navigation Buttons
Figure 3-3: Navigation Buttons
See the following table for button operations in data display mode.
Button
Action
Operations
UP
Press and release
Scroll through pages backwards. Hold down the button for continuous
scrolling.
DOWN
Press and release
Scroll through pages forwards. Hold down the button for continuous
scrolling.
UP + DOWN
Press and release
Return to the start page within a present display.
SELECT
Press and release
Enter programming mode.
MAX/MIN
Press and release
Enter (return from) the minimum/maximum display. Switch between the
Max/Min and Maximum Demands displays.
H/ESC
Press and release
Enter (return from) the harmonics display. Switch between the Total
Harmonics and Individual Harmonics displays.
ENERGY/ENTER
Press and release
Enter (return from) the energy display. Switch between the total and per
phase energy display and TOU registers display (if configured). The button
is not operational in the PM130P.
SELECT +
ENERGY/ENTER
(in selected pages)
Press and hold for
5 seconds or
longer
Reset accumulators or minimum/maximum on the currently displayed page
(see Simple Reset of Accumulated Data below).