Satec PM130 PLUS Series - Common Measurements Display DC Mode

Chapter 3 Using Front Display Data Display
PM130 PLUS Powermeter Series_Installation Operation and Manual 56
10
Ph.L3
PF
kW/MW
Phase L3 powers
(if enabled)
11
kVA/MVA
Ph.L3
kvar/Mvar
Phase L3 powers
(if enabled)
12
H01
PF
kW/MW
Fundamental total powers
(PM130EH, if enabled)
13
H1.L1
PF
kW/MW
Fundamental phase L1 powers
(PM130EH, if enabled)
14
H1.L2
PF
kW/MW
Fundamental phase L2 powers
(PM130EH, if enabled)
15
H1.L3
PF
kW/MW
Fundamental phase L3 powers
(PM130EH, if enabled)
16
U.Unb
V% unb
Voltage unbalance, percent
17
C.Unb
I% unb
Current unbalance, percent
Table 4: Common Measurements (Amp-Demand version)
1
I1
I2
I3
Amps
2
In
Neutral current
3.2.5 Common Measurements Display DC Mode
The DC mode is applicable for PM130 with HACS CT type.
Scroll through pages with the UP and DOWN arrow buttons.
Table 4a: Common Measurements (DC mode)
1
V1
I1
Ph
Summary screen
Line-to-neutral volts
Signed Current (A/kA)
Power (kW/mW)
2
P
V1
V2
V3
Line-to-neutral volts (in 4LN3, 3LN3, 3BLN3 configurations)
3
Ph1 kW/MW
Ph2 kW/mW
Ph3 kW/mW
L1 power (if enabled)
L2 power (if enabled)
L3 power (if enabled)
For Summary screen presentation see Appendix H Summary screen on Local display for DC mode