Satec PM130 PLUS Series - Min;Max and Maximum Demand Display DC Mode

Chapter 3 Using Front Display Data Display
PM130 PLUS Powermeter Series_Installation Operation and Manual 58
10
MAX
DMD
I1
I2
I3
Maximum ampere demands
11
MAX
DMD
kVA/MVA
PF
kW/MW
Maximum VA demand
PF at maximum VA demand
Maximum W demand
12
MAX
DMD
A neut.
var
Maximum neutral current demand
Maximum var demand
Table 6: Min/Max and Maximum Demands (Amp-Demand version)
1
MAX
DMD
I1
I2
I3
Maximum ampere demands
2
MAX
DMD
A neut.
Maximum neutral current demand
3.2.7 Min/Max and Maximum Demand Display DC mode
1. Press the MAX/MIN button.
The MIN, MAX, or MAX DMD LED is illuminated when in the MIN/MAX display.
2. Use the UP and DOWN arrow buttons to scroll through the Min/Max and Max. Demand pages.
To see the time and date of the event occurrence:
3. Press simultaneously the SELECT and UP buttons.
4. Use the UP and DOWN arrow buttons to scroll through the parameters displayed on the page. A
corresponding LED at the right is illuminated showing the parameter for which the timestamp is
displayed.
The time is displayed in format hh.mm, and the date in format MM-DD-YY (default) or in any other format
you can select via the display setup (see Configuring the Display).
Table 7a: Min/Max and Maximum Demands (DC mode)
1
MIN
V1
V2
V3
Minimum volts
2
MIN
I1
I2
I3
Minimum amps
3
MAX
V1
V2
V3
Maximum volts
4
MAX
I1
I2
I3
Maximum amps
5
MAX
DMD
V1
V2
V3
Maximum volt demands
6
MAX
DMD
I1
I2
I3
Maximum ampere demands