Satec PM130 PLUS Series - Status Display

Chapter 3 Using Front Display Status Display
PM130 PLUS Powermeter Series_Installation Operation and Manual 62
3.3 Status Display
The meter has a separate status information display accessible through the primary meter menu. See
Using the Menus for information on navigating in menus.
The Status Display shows rarely used information that is especially helpful for troubleshooting or when
connecting the meter to an external equipment.
To access the Status Display:
1. From the Data display, press the SELECT button to access the primary meter menu.
The StA window is highlighted.
2. Press ENTER to access the Status Display.
3. Use the UP and DOWN arrow buttons to scroll through the status pages.
Figure 3-4: Status Display
To exit the Status Display:
1. Press ESC to return to the primary device menu.
2. Press ESC to return to the Data display.
Table 14: Status Display Parameters
1
PhS
rot
POS/nEG/Err
Phase rotation order
2
A.
V1 angle
V2 angle
V3 angle
Voltage angles (±180°, referenced to V1)
3
A.
I1 angle
I2 angle
I3 angle
Current angles (±180°, referenced to V1)
4
rEL
1.2
00
Relay status (with a digital I/O module)
5
St.In
1.2.3.4
0000
Status inputs (with a digital I/O module)
6
Cnt.1
<hour>
12345
Counter #1 value (a time counter – in 0.1 hour units)
7
Cnt.2
<hour>
12345
Counter #2 value (a time counter – in 0.1 hour units)