GPRS communications status (with an external GPRS modem):
RSSI = received signal strength, dBm
GPRS status: Uncon = not connected,
UnrEG = not registered, rEG = registered
3.3.1 Pulse and Time Counters
You can use the 5-digit meter counters either as regular pulse/event counters to count external pulses or
setpoint events, or as time counters to count setpoint operation time.
See Configuring Counters in Chapter 5 for information on configuring pulse/event counters.
See Using Time Counters in Configuring Alarm/Control Setpoints for information on configuring time
counters. Time counters have the hour label in the middle window and indicate the setpoint operation time
in 0.1-hour units.
You can clear a counter using the simple “two-button” reset option if the meter is not password protected,
or if the meter security is overridden by the “two-button” reset mode setting (see Configuring the Display).
To clear a counter:
1. Select a counter page.
2. While holding the SELECT button, press and hold the ENTER button for about 5 seconds.
The displayed data is reset to zero.
3.3.2 Alarm Display
The alarm display shows a list of operated alarm setpoints along with the alarm trigger labels if there are
alarms recorded during meter operation.
Use the UP and DOWN arrow buttons to scroll through the alarm list.
The setpoint status is latched into a non-volatile register, which is not affected by loss of power and may
only be cleared via communications or from the meter display.
To clear alarms:
1. Select an alarm page.
2. While holding the SELECT button, press and hold the ENTER button for about 5 seconds until
the alarm code is reset to none.
To Next Page
Loading...
