Chapter 3 Using Front Display Using the Menus
PM130 PLUS Powermeter Series_Installation Operation and Manual 65
3.4.2 Selecting Menus
To access the menus, press and release the SELECT button. The primary meter menu is displayed as
shown in the picture below.
The menu has three entries:
• StA: Status Display entry (see the Status Display section)
• OPS: Main setup menu entry allowing to review setup options
• CHG: Main setup menu entry allowing changing setups, updating the clock and resetting
accumulated values.
To access the Status Display:
1. If the StA window is not highlighted, use the SELECT button to activate it.
2. Press the ENTER button to access the Status Display
To review the meter setup options:
1. Press the SELECT button to activate the OPS window.
2. Press the ENTER button to access the main menu.
To change the meter setup:
1. Press the SELECT button to activate the CHG window.
2. Press the ENTER button to access the main menu.
3.4.3 Entering the Password
The Setup Change menu can be secured by a four-digit user password.
You can change the password and enable password protection through the Access Control menu (see
Configuring Meter Security). The meter is primarily shipped with the password preset to 0 and password
protection disabled.
If password protection is enabled, you are prompted for a password when entering the setup change menu.
To enter the password:
1. Adjust the first digit with the UP or DOWN arrow buttons.
2. Press the SELECT button to advance to the next digit. As you move to the next place, the entered
digit is saved and then zeroed. If you missed a digit, you should re-type all preceding digits before
you reach the missed place again.
3. Adjust the remaining digits in the same manner.
4. Press ENTER to confirm the password.
If the password you entered is correct, you are moved to the Main menu, otherwise you return back to the
primary menu.
To Next Page
Loading...
