Satec PM130 PLUS Series - Viewing and Changing Setup Options

Chapter 3 Using Front Display Using the Menus
PM130 PLUS Powermeter Series_Installation Operation and Manual 67
3.4.5 Viewing and Changing Setup Options
A second level menu normally consists of three items:
• the upper static window indicates the menu name
• the middle window represents a list of setup parameters you can scroll through
• the lower window shows the parameter value.
To select a parameter you want to view or change:
1. Highlight the middle window by pressing the SELECT button.
Figure 3-6: Selecting a Parameter
2. Scroll through the parameter list with the UP or DOWN arrow buttons until the required parameter
name appears.
To change the selected parameter:
1. Press the SELECT button to highlight the lower item.
Figure 3-7: Changing a Parameter
2. If the parameter is represented by a list of values, select the required option with the UP or DOWN
arrow buttons.
3. If the parameter is represented by a numeric value, adjust the number with the UP or DOWN
arrow buttons. When the button is briefly pressed and released, the number is incremented or
decremented by one. When the button is pressed continuously, the number is changed
approximately twice per second.
4. Press the ENTER button to store your selection or press the ESC button to leave the parameter
unchanged.
5. You return to the middle window and can continue scrolling through the remaining parameters or
return to the main menu.
6. Press ESC to exit the menu.