Chapter 4 Using PAS Software Setting Up the Meter
PM130 PLUS Powermeter Series_Installation Operation and Manual 72
4.4 Setting Up the Meter
4.4.1 Preparing Setups for the Meter
PAS allows you to prepare setup data for your meter off-line without the need to have it connected to your
PC.
To prepare a setup for your meter:
1. Select the device site from the list box on the PAS toolbar.
2. Select the desired setup group from the Meter Setup menu. Click on the tab with the setup you
want to create or modify.
3. Fill in the boxes with the desired configuration data for your meter.
4. Click the Save as… button to store the data to the meter site database.
5. Click OK.
Always set up and store the Basic Setup data to the site database first. PAS uses this data as a
reference when arranging other meter setups.
To save your setup to another site database:
1. Click the Save as… button.
2. Select the target database from the file pane.
3. Click OK.
You can also reuse a setup from another site by copying it to your present site database.
To copy a setup from another site’s database:
1. Click Open.
2. Select the desired source site database.
3. Click OK. The opened setup is copied to your dialog window.
4. Click the Save as… button.
5. Select the target database from the file pane.
6. Click OK.
To copy all setups from one site database to another site's database:
1. In the list box on the toolbar, select a source device site from which you wish to copy setups.
2. Select Copy to... from the Meter Setup menu.
3. Select the target site database to which you wish to copy setups, and click OK.
To Next Page
Loading...
