Satec PM130 PLUS Series - Chapter 5 Configuring the PM130 PLUS; Configuring Communications; Setting up Serial Communication Ports

Chapter 5 Configuring the PM130 PLUS Configuring Communications
PM130 PLUS Powermeter Series_Installation Operation and Manual 75
Chapter 5 Configuring the PM130 PLUS
This chapter describes how to configure different options in your meter from the front panel display or via
PAS.
5.1 Configuring Communications
5.1.1 Setting Up Serial Communication Ports
Using the Front Display
Select Prt1 for COM1 or Prt2 for COM2 from the main menu. See Viewing and Changing Setup Options
in Chapter 3 for information on configuring parameters via the front display.
See Table 15 below for available communication options.
Using PAS
Select Communications Setup from the Meter Setup menu, and then click on the Serial Ports Setup
tab. In the Port box, select the desired device port.
Figure 5-1: Communication Setup Dialog Box – Serial Ports Setup Tab
See Table 15 below for available communication options.