Satec PM130 PLUS Series - Setting up Ethernet

Chapter 5 Configuring the PM130 PLUS Configuring Communications
PM130 PLUS Powermeter Series_Installation Operation and Manual 77
5.1.2 Setting Up Ethernet
Using the Front Display
Select nEt from the main menu. This menu entry appears only if the optional Ethernet module is
plugged into the meter. It allows you to set up the meter network address and the default gateway.
See Viewing and Changing Setup Options in Chapter 3 for information on configuring parameters via the
front display.
Using PAS
Select Communications Setup from the Meter Setup menu, and then click on the Network Setup tab.
Figure 5-2: Communication Setup Dialog Box – Network Setup Tab
The table below lists available network options.