Satec PM130 PLUS Series - Setting up Wifi Network

Chapter 5 Configuring the PM130 PLUS Configuring Communications
PM130 PLUS Powermeter Series_Installation Operation and Manual 79
The following table lists available GPRS options.
Table 17: GPRS Setup Options
Parameter
Default
Description
Access Point Name (APN)
internetg
The mobile network APN name
User name
Username (if required)
Password
Password (if required)
2. Configure your mobile network APN, username, password and GPRS Client/Server mode.
Consult your network operator regarding proper network settings. Leave the username and
password fields blank if network authorization is not required.
3. Send your GPRS settings to the meter.
4. Select the GPRS interface in the COM2 port setup (see Setting Up Serial Communication Ports).
5. Configure your eXpertPower client (see Setting Up eXpertPower Client) or/and TCP Notification
client (see Setting Up TCP Notification Client) for communicating with a remote server.
You can check the status of the GPRS communications from the front panel via the Status Display or via
the Device Control dialog in PAS (see Viewing Communication Status and Statistics).
5.1.4 Setting Up WiFi Network
WiFi communications is available in the meters equipped with a WiFi expansion module.
Make sure the power is off before attaching a WiFi expansion module to the meter to avoid
damage to sensitive electronic components.
A WiFi module can be configured to work in one of the following modes:
a) as a regular WiFi station for connection of the meter to an existing WiFi network;
b) as a WiFi access point/router to create a separate secured WiFi network without using an
additional external router. It also serves as a network gateway for the connected meter.
When access point mode is disabled (see instructions below), the module operates as a regular WiFi
station.
Use the accompanying PAS software to configure WiFi communications in your meters.