Chapter 5 Configuring the PM130 PLUS Configuring Communications
PM130 PLUS Powermeter Series_Installation Operation and Manual 83
Monitoring a WiFi Connection
If your WiFi module is properly configured, the meter will automatically connect to the WiFi network any
time the meter is restarted.
You can monitor the connection status and signal quality via the meter front display or via PAS.
To check a WiFi connection from the meter display:
In the EM133, move to the Diagnostics display and then scroll to the “WiFi” page where you can see the
network connection status and received signal quality. The following page indicates the meter network
address.
In the PM130, move to the STA display and then scroll to the “rSSi” page where you can see the received
signal quality in percent followed by the network connection status.
In the PM135, move to the Device Info display and then scroll to the “WiFi” page.
To check a WiFi connection via PAS, select Device Control from the Monitor menu and click on the
Communications tab. The connection status and received signal quality are indicated under the WiFi
Wireless Communications section.
To Next Page
Loading...
