Chapter 5 Configuring the PM130 PLUS General Meter Setup
PM130 PLUS Powermeter Series_Installation Operation and Manual 98
Using PAS
Select General Setup from the Meter Setup menu, and then click on the Pulse/Event Counters tab.
Table 25 lists available counter options.
Table 25: Counter Options
None,
DIGITAL INPUT
#1 - #12
Links a digital input to the counter
The value added to the counter when a pulse is
detected on the pulse source input
Displays the present counter contents
Figure 5-11: General Setup Dialog Box – Pulse/Event Counters
You can preset a counter to a required value or clear it without affecting the counter setup.
To preset or clear a counter:
1. Click the Online button on the PAS toolbar before accessing the setup dialog box.
2. Type in the required value into the Counter Value field.
3. Click Send.
To Next Page
Loading...
