6 ASP-200 SATEL
4. Remove the battery cover (grasp the upper part of the cover with your fingers and pull it
down).
5. Remove the old battery and place the new one in the battery cover.
6. Install the battery cover in the siren enclosure.
7. Press and hold down the tamper switch.
8. Connect the new battery.
9. When the leftmost LED on the siren starts flashing every second, release the tamper
switch. The flashing LED indicates that the battery is being initialized. The siren will not be
ready for normal work, until the LED stops flashing.
To Previous Page
Loading...
