Unit 4: Standard Command Codes
E/Pro Programming Reference
4-66 PN: 9001096E
NOTES
Both Formats
The parameter feature varies depending on 1D barcode symbology. The parameter for barcode height
is only designable for UCC/EAN128 (EU11, EU12).
The print data parameter can accept up to 120 digits for 1D and 2D data. For 2D data, when 1D
barcode symbology and alphanumeric are mixed, the designable data quantity may vary.
The entire composite symbol size changes depending on the specification of minimum bar width.
If the composite symbol exceeds the printable area, only the portion located within the area will print;
however, a scanner may occasionally read such a composite symbol.
If the value in 1D barcode symbology is not set to the data portion, the composite symbol will not print.
This command does not support the RSS Expand command.
Print of HRI cannot be designated with this command.
Rotation <ESC>% is available, but Enlargement <ESC>L is disabled.
Format 2
Barcode height (c) is specified when Minimum Bar Width is “01”. For instance, if setting Minimum Bar
Width to 03 and Barcode Height is 100, the Barcode Height will be 300 dots.
To specify the print of composite symbol, delimit 1D and 2D data with “I” (7Ch). Use “#” (23h) to specify
FNC1 (GS) of CC-C for PDF417) as data.
EAN/UCC COMPOSITE SYMBOL
To Next Page
Loading...
