Unit 4: Standard Command Codes
E/Pro Programming Reference
4-88 PN: 9001096E
MULTIPLE CUTS
FUNCTION
Cuts a specified quantity of time for a specified quantity of labels resulting in one or more
labels between each cut sequence.
FORMAT
<ESC>~(NULL)aaaa
a = Print quantity until cut (0 to 9999)
Place immediately following the <ESC>Q command.
EXAMPLE
<ESC>A
<ESC>V100<ESC>H200<ESC>P2<ESC>L0202<ESC>XMABC
<ESC>Q4
<ESC>~2
<ESC>Z
OUTPUT
(4-56)
NOTES
Only valid for cutter specified models.
One cut per label when <ESC>~ is not specified at the Cut Motion Mode.
Do not perform cut when at a=0.
The accumulation of print labels and cut quantity shall not exceed a maximum of 999999.
Command <ESC>Q specifies the sheet quantity to be cut.
This command cannot be used in conjunction with the <ESC>~A command.
To Next Page
Loading...
