Unit 4: Standard Command Codes
E/Pro Programming Reference
4-12 PN: 9001096E
NOTES
1. When a sectional number value outside of the range is specified, it will be processed as “0.”
(Command error will not occur.)
2. When the pattern designation value is outside of the range specified, it will be processed as
“0.” (Command error will not occur.)
3. When the print start position is outside of the printable area, printing will not be performed
due to command error.
4. This command sets the base reference point to the center of a circle.
5. This command can be registered to the format.
6. If setting the line width wider, it will be widened to the inside circle.
PRINT CIRCLES
<V>100
<H>200
0,0
100 in radius
To Next Page
Loading...
