SATO CL408 - Error Signals M8400 RV and M84 S Series Printers (some Procedures Are Not NA for M-8459 S)

Programming Manual 6. Troubleshooting
SATO RISC Printers 191
6.5 Error Signals M8400RV and M84S Series Printers
(Some of the following procedures are not NA for M-8459S)
LED LCD
MESSAGE
AUDIBLE
BEEP
ERROR
CONDITION
TO CLEAR
Error On Machine
Error
1 Long Machine Error Switch power ON/OFF
Error On EEPROM
Error
1 Long EEPROM
Read/Write
Switch power ON/OFF
Error On Head Error 1 Long Head Switch power ON/OFF
Error On Sensor
Error
3 Short Sensor Switch power ON/OFF
Error Blinks Card R/W
Error
1 Long Memory Card
Read/Write
Switch power ON/OFF
Error Blinks Card Low
Battery
1 Long Memory Card
Battery Low
Switch power ON/OFF
Error Blinks Head Open 3 Short Head Open Close head lever
Error Blinks Cutter Error 3 Short Cutter Switch power ON/OFF
Error On
Line Blinks
PARITY
ERROR
3 Short RS232 Parity
Error
Switch power ON/OFF
Error On
Line Blinks
Overrun
Error
3 Short RS232Overrun
Error
Switch power ON/OFF
Error On
Line Blinks
Framing
Error
3 Short RS232 Fra-
ming Error
Switch power ON/OFF
Error On
Line Blinks
Buffer Over 3 Short Buffer Overflow Switch power ON/OFF
Error Blinks
Label On
Paper End 3 Short Label End Open/close Head
Lever Open/close
Label Hold down
Error Blinks
Ribbon On
Ribbon End 3 Short Ribbon End Open/close Head
Lever Open/close
Label Hold down
Error Blinks
Label Blinks
Media Error 3 Short Media Error Open/Close Head
Lever
Ribbon
Blinks
None Ribbon Near
End
Replaceribbonwithfull
roll
Line Blinks None Buffer Near Full Slow down transmis-
sion rate