SATO CL408 - SECTION 4. PROGRAMMING; INTRODUCTION; THE SATO CL PROGRAMMING LANGUAGE

36 SATO RISC Printers
2. Command Codes Programming Manual
Character, Fixed Spacing
Command Structure:
<ESC>PR
Example: See Above
Placement: Preceding the data
Default: The default is Proportional Spacing.
Function:
To reset proportional spacing and place the printer to fixed spacing.
Input:
<ESC>A
<ESC>H0025<ESC>V0050<ESC>PS
<ESC>L0202<ESC>XMPROPORTIONAL SPACING
<ESC>H0025<ESC>V0130<ESC>PR
<ESC>L0202<ESC>XMFIXED SPACING
<ESC>Q1<ESC>Z
Output:
Note:
1. This command only works with the proportionally spaced fonts
XU, XM, XS, XL and XB.
2. Once this command is sent in the data stream, it is in effect until
the end of the print job or a reset command is sent.