SATO CL408 - Form Overlay, Recall; Command Structure; Special Notes

Programming Manual 2. Command Codes
SATO RISC Printers 57
Job ID Store
Command Structure:
<ESC>IDaa
aa: JobIDassigned(01to99)
Example: <ESC>ID09
Placement: Immediately following the <ESC>A in the job data
stream.
Default: None
Function:
To add an identification number to a job. The status of the job can then
be determined using the ENQ command in the Bi-Com status mode
(See Interface Specifications for more information).
Input:
<ESC>A
<ESC>ID02
...Job...
<ESC>Z
Output:
There is no printer output as a result of this command.
Note:
1. Works only in Bi-Com mode. The Job ID number must be stored
before Bi-Com status mode can be used.
2. If more than one ID number is sent in a single job, the last number
transmitted will be used, i.e.
<ESC>A
<ESC>ID01
..........
<ESC>ID02
.........