58 SATO RISC Printers
2. Command Codes Programming Manual
Journal Print
Command Structure:
<ESC>J
Example: See above
Placement: Immediately following <ESC>A
Default: None
Function:
To print text in a line by line format on a label. By specifying this com-
mand, you automatically select Font XS with a Character Expansion
of 2x2. You also establish a base reference point of H2,V2. The cha-
racter pitch is 2 dots and the line gap is 16 dots. Simply issue an ASCII
<CR> at the end of each text line.
Input:
<ESC>A
<ESC>J WITH THE JOURNAL FEATURE
YOU CAN PRINT TEXT WITHOUT
USING ANY FONT COMMANDS
OR POSITION COMMANDS
<ESC>Q1<ESC>Z
Output:
Note:
1. Journal mode assumes a maximum label width . Otherwise, you
may print where there is no label and damage your print head.
2. It is effective only for the current print job.
To Next Page
Loading...
