SATO CL608e - Pitch Offset and Direction

28 CL608e/612e
3. Configuration Operation Manual
3.3.5 Pitch Offset and Direction
The label pitch is the distance from the leading edge (the edge that
comes out of the printer first) of a label and the leading edge of the
next label. The leading edge position of the label can be adjusted
relative to the print head +/- 49 mm in increments of 1 mm using
the following procedure. Once the position is set, it can be adjusted
+/- 3.75 mm using the PITCH potentiometer on the adjustment
panel.
The label pitch is the distance from the leading edge (the edge that
comes out of the printer first) of a label and the leading edge of the
next.
To change the setting perform the following steps:
1. Use the LINE key to step the blinking cursor to either the positive
(+) or the negative (-) selection. A positive selection moves the
leading edge of the label forward (away from the print mecha-
nism) while a negative selection moves the leading edge of the
label back into the mechanism.
2. Once the correct setting is selected, press the FEED key to
accept the setting and advance to the Pitch Offset adjustment.
3. Use the LINE key to step the counter to the desired position.
The display will increment one step for each time the LINE key
is pressed. The reading will advance to a setting of 4 mm for first
LINE FEED
DIRECTION
MOVED WITH MINUS(-)
OFFSET
ORIGINAL PRINT LINE
MOVED WITH
POSITIVE(+) OFFSET
PITCH OFFSET
+
00mm
PITCH OFFSET
+00mm