Page 3-7
Section 3. Interface Specifications
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
RS232C Serial Interface
Cable Requirements
* This connection at the host side of the interface would depend upon the pin that is being used as the
Ready/Busy signal by the driving software. Typically on a PC, it would be either CTS (pin 5) or DSR (pin 6)
on a DB-25 connector.
9BD52BDTSOHNOITCENNOCRETNI52BDRETNIRP
11 GF1)dnuorGemarF(GF
23 DR2)ataDtimsnarT(DT
32 DT3)ataDevieceR(DR
85 STC4)dnesottseuqeR(STR
74 STR5)dneSotraelC(STC
402TRD6)ydaeRteSataD(RSD
66 *RSD02)ydaeRlanimreTataD(RTD
57 GS7)dnuorGemarF(GS
Please Note:
SATO does not recommend the use of mechanical data switches commonly called A/B
switches, as they are known to damage both the computer and printer serial ports.
To Next Page
Loading...
