Section 2: Command Codes
SATO CX400 PN 9001106 Rev. A Page 2-43
Off-Line/Pause
Command Structure <ESC>@
Example: See above Placement: Anywhere in the print job between
the <ESC>A and <ESC>Z
Default: None
Command Function To specify the printer to come to an off-line state. When used within a print
job, the printer goes off-line after finishing the print job.
Input to Printer <ESC>A
<ESC>@
...Job...
<ESC>Z
Printer Output There is no printer output for this command. The printer is placed in the
Off-Line mode as soon as the current print job is finished.
Special Notes 1. You must press the FEED key on the front panel for more than 5 sec-
onds to return the printer to an On-Line status. Note: the print buffer
will be cleared.
2. Remember, when using this command, that the print job specifies
<ESC>Q10, all ten labels will print before the printer goes off-line
To Next Page
Loading...
