SATO GT424 - Page 11

Section 1: Introduction
GT Series Operator’s Manual Page 1-5
1.1 GENERAL SPECIFICATIONS (CONT’D)
Specification/
Model Name
GT408 GT412 GT424
External interface
Interface board
¤ Parallel (IEEE1284)
¤ RS-232C
• READY/BUSY
• XON/XOFF
• Status 2/3
• Driver specific protocol
• Status 5
¤ USB (Ver. 2.0)
¤ LAN (10BASE-T/ 100BASE-TX automatic changeover)
¤ Wireless LAN (IEEE802.11b)
¤ Mini LAN (10BASE-T/ 100BASE-TX automatic changeover)
External (EXT) signal interface (14-pin)
Operation
Panel
Buttons
LINE, FEED
FUNCTION, 4 navigation buttons (up/down/left/right), ENTER, CANCEL
Switch POWER ON/OFF
LCD Green LCD (with backlight), Vertical 32 dots x horizontal 128 dots, displaying up to five
icons at the top of the screen
LEDs POWER, ONLINE, STATUS, LABEL, RIBBON status indicators
Adjustment
Potentiometer
VOLUME: buzzer loudness adjustment
PITCH: print-head pitch adjustment
OFFSET: tear off, peel, and cutter stop position adjustment
DARKNESS: print density adjustment
Sensor Paper sensor: reflection type, penetration type
Memory cartridge
16 MB FLASH ROM, 4 MB non-volatile user memory
Print Format Transmitted from host (computer) or recalled from print formats stored by user
on memory card (optional)
Stored
Font Types
Standard X20 5 x 9 dots (alphanumeric, symbol, and kana)
X21 17 x 17 dots (alphanumeric, symbol, and kana)
X22 24 x 24 dots (alphanumeric, symbol, and kana)
X23 48 x 48 dots (alphanumeric, symbol, and kana)
X24 48 x 48 dots (alphanumeric, symbol, and kana)
Outline font (alphanumeric, symbol, and kana)
OCR-A GT408 15 x 22 dots (alphanumeric and symbol)
GT412 22 x 33 dots (alphanumeric and symbol)
GT424 44 x 66 dots (alphanumeric and symbol)
OCR-B GT408 20 x 24 dots (alphanumeric and symbol)
GT412 30 x 36 dots (alphanumeric and symbol)
GT424 60 x 72 dots (alphanumeric and symbol)
Truetype Fonts
CG Times (alphanumeric and symbol)
CG Triumvirate (alphanumeric and symbol)
Kanji Fonts
(where applica-
ble)
16 x 16 dots (JIS level-1 and -2 kanji sets. Selectable either Mincho or Gothic)
24 x 24 dots (JIS level-1 and -2 kanji sets. Selectable either Mincho or Gothic)
22 x 22 dots (JIS level-1 and -2 kanji sets. Selectable either Mincho or Gothic)
32 x 32 dots (JIS level-1 and -2 kanji sets. Selectable either Mincho or Gothic)
40 x 40 dots (JIS level-1 and -2 kanji sets. Selectable either Mincho or Gothic)
Kanji outline font