SATO GY412 - Section 2: Installation

Section 2: Installation
GY412 Operator Manual Page 2-9
2.4 CONNECTIONS, CONT’D
SD Card Folder Architecture
DATA
PROG
FONT
Firmware
Firmware : PRG42_XX
.BIN (XX : Reg. No. 01 to 09)
Kanji outline font : Kan1_O.BIN
Kanji font (Ryobi font) : Kan1_RX
.BIN (X : Reg. No. 1 to 9)
SEMBL program : SEMBL.BIN
Data for memory card command
Form overlay registration ：SBPLXXXX.OVL (XXXX : Reg. No.0001 to 0099)
Format registration : SBPLXXXX
.FMT (XXXX : Reg. No. 0001 to 0999)
Graphic registration: SBPLXXXX
.IMG (XXXX : Reg. No. 0001 to 0999)
BMP file registration  : SBPLXXXX
.BMP (XXXX : Reg. No. 0001 to 0999)
PCX file registration  : SBPLXXXX
.PCX (XXXX : Reg. No. 0001 to 0999)
Memory card 16x16 Extended character registration : SBPL16.BMF
Memory card 24x24 Extended character registration : SBPL24.BMF
PR42
SD card route
Download font / log
Download font data : USRFONTX
.DAT(X : Reg. No. (1 to 6))
CONF
Printer configuration information
Printer configuration information file : PRN42.INI
RAS
Rasterized font
No corresponding files for GY412
LOG
Maintenance
Receive buffer: RCVBUF.DAT
STATUS5 log : HISTSTS5.DAT
FRAM dump: FRAMDMP.DAT