SATO LM412e - Page 24

English n
‒
4
‒ Place an empty ribbon core on the
ribbon take-up spindle.
‒
‒
‒
‒
‒
‒
5
From the ribbon supply spindle,
thread the carbon ribbon under
the thermal head and to the
ribbon take-up spindle.
Tape the free end of carbon
ribbon to the ribbon core, and
wind a few times in the direction
of the arrow shown.‒
Be sure to confirm that the carbon
ribbon is set as shown in the picture
on the right.‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒

*Thermal head and the surrounding
areas will become hot during the
printing process.
 When changing the labels after
printing, be careful not to get burnt.
*Contacting the edge of thermal head
with bare hands may result in injury.
When changing the labels, be
 careful not to get injured.
Caution
Ribbon core
Tape
Ribbon
take-up
spindle
16
LM400eクイックガイド070806.inddE16
LM400eクイックガイド070806.inddE16
2007/08/0611:03:01
2007/08/0611:03:01