A P P E N D I X D
D-3
SWING GUIDE INSTALLATION, CONTINUED
7. Separate the two swing guide frame plates by
removing the two thumb screws, and divide the
swing guide assembly.
8. Install the inner swing guide assembly and
mounting brackets (four screws) to the upper frame
as shown in Figure D-5.
Note: To ensure proper installation of the
swing guide assembly, temporarily
fasten the screws at the front right, rear
left, and rear right of the guide
assembly. Then adjust the front and
rear of the guide assembly to ensure
proper alignment to the swing guide
drive gear assembly and fasten the
three screws. The remaining front left
screws can now be fastened.
Note: To ensure maximum performance
of the swing guide assembly, be sure
that the swing guide drive motor gear
and the swing guide drive gear are
properly aligned.
9. Insert the guide film of the swing guide assembly
(inner side) into the hole.(See Figure D-6)
10. Insert the swing guide front plate to the assembly
by tilting it approx. 30 degrees (See Figure D-7)
Figure D-5
Figure D-6
Figure D-7
To Next Page
Loading...
