LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-47 April, 2014
of 128 pages
5. Each segment of System Time (HH:MM:SS) is set by:
a. Pressing the Down triangle to change the time segments to an earlier time
or pressing the Up triangle to change the time segments to a later time.
b. Press Enter after each change to advance to the next segment.
6. Pressing Enter, after the SS time segment has been entered, sets the new
System Time and returns the system to the Supervisor Menu.
To Next Page
Loading...
