LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-73 April, 2014
of 128 pages
Print Width
The Print Width setting specifies, in inches, the print width of the document to be
printed.
Note: The Print Width setting can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Print Width function.
2. Press Enter, which causes the following Print Width screen to display:
Figure 6-57. Print Width screen.
Note:
Pressing UN permits changing the units and all associated numeric data to
any one of the following:
- inches
- mm
- 7,200/Inch
- Scan lines
- Dots 1/400
Pressing CL after entering numeric data deletes 1 digit each time pressed.
3. The print width can be either increased or decreased in 0.1000” increments,
from a minimum of 5.0000” to a maximum of 17.0000”.
Current
print
width
To Next Page
Loading...
