SATO S84 ex - Page 111

4 Operation and Configuration
109
S84-ex/S86-ex Operator Manual
CHARACTER BIT
Set the RS-232C data length.
The following options are available:
•7BIT
•8BIT
Note
• Shows only if the RS-232C interface is selected.
• The setting will be effective after you power on the product again.
PROTOCOL
Set the communication protocol.
• READY/BUSY: When selected, the product will proceed to the
RECEIVE BUFFER screen.
• XON/OFF: When selected, the product will proceed to the RECEIVE
BUFFER screen.
• STATUS2: When selected, the product will proceed to the IGNORE
CR/LF screen.
• STATUS3: When selected, the product will proceed to the IGNORE
CR/LF screen.
• STATUS4: When selected, the product will proceed to the IGNORE
CR/LF screen.
• STATUS5: When selected, the product will proceed to the ITEM NO.
CHECK screen.
Note
The setting will be effective after you power on the product again.
ITEM NO. CHECK
Set the item number check function.
• ENABLE: Enable the item number check function.
• DISABLE: Disable the item number check function.
Note
Shows only if PROTOCOL is set to STATUS5.