SATO S84 ex - Media Back Feed Load Tolerance

7 Appendix
114
S84-ex/S86-ex Service Manual
7.1.3 Media Back Feed Load Tolerance
The constant force pulling the liner by the liner rewinder must be as follows:
Criteria of tolerance
• The print position difference between the media load and no media load should be within ±1.5 mm.
• Should not include the change due to the ribbon diameter.
• Should not include the change due to temperature and humidity.
• Should not include the shock.
Media Width Liner Width Media Back Feed Load Tolerance
From 10 to 15 mm From 13 to 18 mm Less than 150 g
From 15 to 45 mm From 18 to 48 mm Less than 300 g
From 45 to 60 mm From 48 to 63 mm Less than 400 g
From 60 to 80 mm From 63 to 83 mm Less than 650 g
80 mm and above 83 mm and above Less than 800 g