SATO WS408DT - Page 59

Configuration and Interface set up
WS4-DT/TT-r01-12.1.17-OM-RS
53
￭ SDPL, SEPL, SIPL, SZPL and AUTO
SDPL, SEPL, SIPL, SZPL and AUTO provides settings grouped in the Supply, Control,
Action, Label and Position Adjustment area.
Property Name
Description
Sensor Type
It is the media sensor you are using. It includes I-MARK,
GAP and None. When you perform media calibration, the
sensor is set to the one you select.
Ribbon Sensor
Thermal Transfer Your printer uses the ribbon sensor to
detect the ribbon for Thermal Transfer (TT) operation.
Direct Thermal The ribbon sensor is disabled for Direct
Thermal use.
Feed Key
It defines the action of the FEED button.
Feed Your printer feeds a blank label each time the
button is pressed.
Reprint Your printer reprints the last label each time the
button is pressed.
Head Check(Power
on)
Enable Your printer checks broken pins on the printhead
automatically once your printer is turned on.
Disable Disable the auto head check.
Auto Calibration
ON (Power on) Your printer automatically calibrates
media using a media sensor once it restarts or is turned on.
ON (Head close) Your printer automatically calibrates