Configuration and Interface set up
WS4-DT/TT-r01-12.1.17-OM-RS
66
4. Do one of the following to configure your IPv4 settings:
∙ If you have a static IP address, fill the IP Address, Subnet Mask and
Gateway box under IPv4 according to your network settings, make sure
DHCP is disabled, and click Send.
∙ If you don’t have a static IP address, make sure DHCP is enabled and
click Send.
5. After your printer restarts, click Get to get the IPv4 information of your
printer. If you are using a static IP address, you’ll get the same settings as
it is in the previous step; if you are using DHCP, the DHCP server will
automatically populate the IP Address, Subnet Mask and Gateway boxes
under Current IPv4.
To Next Page
Loading...
