satoh Buck S-470D - Fuel Pump Air Bleeding; Fuel Pipe Air Bleeding

FUEL PUMP AIR BLEEDING
Loosen the air vent screw of the fuel pump to let the fuel to overflow.
When no more air bubbles in the fuel, tighten the screw.
NOTE: ________________________________________ __
With this operation, the engine can be started, but if not, bleed the
injection pipe.
FUEL PIPE AIR BLEEDING
Loosen the nut of the injection nozzle and shift the throttle lever to the
high speed position. Then, start the engine by operating the starter motor
and make sure the fuel is discharged properly at the loosened nozzle
connection. Tighten the nut to the specified torque.
Start the engine according to the steps covered by "Starting the Engine".
NOTE: __________________________________________ __
Unless air is completely bled, the engine can not be started; in such a
case,
perform air bleeding again to let remaining air completely out of
the system.
-34-