satoh Buck S-470D - Clutch Pedal Adjustment; Free Play Adjustment; Brake Pedal Adjustment

CLUTCH PEDAL ADJUSTMENT
Clutch pedal free play is very important and it must be always main-
tanined to be correct. If there is no free play, the clutch disc will wear
quickly, while too much free play will cause difficult disengagement of
the clutch even if the pedal is fully depressed, resulting in hard gear shift.
FREE PLAY ADJUSTMENT
The free play in the clutch pedal should be between 25 and 30 mm (1
and 1.2 inch) and storoke is 60 ~ 75 mm (2.4 ~. 3.0 inch).
I
I
I
After loosened the clevis lock nut pull the split pin out of the setting pin
for the clutch pedal and joint, remove the pin and adjust the clutch pedal
free play to be 25 ~ 30 mm (1 ~ 1.2 inch) turn ing the joint. After
proper adjustment set the cotter pin and lock the clevis securely with
lock nut.
NOTE: ________________________________________ __
This adjustment is important for maintaining the clearance between the
release lever and the release bearing to obtain a smooth gear shift and
transfer all the driving power to the transmission.
BRAKE PEDAL ADJUSTMENT
Free play of the brake pedal must be maintained within the correct
range, otherwise, accidents may occur or power will be lost.
Before the brake on one side becomes unadjustable even by means of the
rod, caused by earlier wear of the brake lining due to its more frequent
use than the other, periodically interchange the right and left brake
shoes. Special care should be taken in the case of frequent using of only
the brake on the same side. - 44 _