Trouble Shooting
High voltage fault (refer to page 7-10)
Ink overfilled fault (refer to page 7-10)
Communication fault (refer to page 7-10)
7-5
Aug. 2008
When a fault occurs, the following happens:
hat Happens When a
Fault Occurs?
The fault message will be displayed in the “Fault Report
Zone” of the screen and the red LED on the <Ink Jet Key> will
be lighten.
The fault message of which kind will be displayed at the
“Fault Report Zone” of the screen. Relative engineer should
maintain the printer and clear the alarm status. The faults or
warning should be saved on the faults recorder in the
<System setup> for the service engineer.
If several faults occur at the same time, the fault warning will
be display at the screen until the trouble been solved, and
the four-minute shutdown sequence begins (without “Auto
Flush”).
If the warning occurs, printer could continue to work.
If the normal fault occurs, printer will shutdown
automatically.
If a panic fault occurs, the printer will shutdown immediately
(shut off all the solenoids).
hat is Need to Do
When a Faults Occurs?
When a fault occurs, please refer to the "Cause/Solution" table
for that particular fault and try the solutions provided to solve the
problem.
CAUTION: After the Panic fault occurred, the maintainance will
be needed immediately, you need try to solve the problem to
avoid the remained ink in the recovery tube clogged.
Common phenomenon
and Solution for Faults
The following content covers all the faults of the printer. Every
fault has detailed consequence and solution. Please use this
information to solve the problems.
To Next Page
Loading...