Installation
4-4
Site Preparation
Position the printer near the conveyor. Consider the following
guidelines:
Determine Printe
Location
The area selected should be free of vibration.
Make certain that the print head can reach the conveyor
and there is some space left for operator to disassembly
and clean the print head.
Make certain that the power supply and ground wire can
reach the printer.
There should be enough space left for opening the door to
maintain and service the printer.
Electrical Requirements
The Microdot printer operates at 110/220 VAC±10%, 50-60 Hz.
Voltage / Frequency
Power Consumption
90 Watts maximum, 50 Watts typical.
To Next Page
Loading...