Saturn S Series - Page 84

INK JET PRINTER OPERATION
5-32
Message INV/REV
It is used to control the direction of print (inverse or reverse).The
procedures as below:
1. Enter <Print Setup-2>, select <Message INV/REV>, it displays as
below:
2. Use up/down <Direction Key> and right/left <Adjust Key> to
change the status of “Reverse” and “Invert” respectively to meet
the production demand;
3. Press <OK> to confirm the settings.
Encoder Setup
It must be installed an encoder to keep the print speed synchronizing
with the product line if the line speed is unstable or needed to be
changed. The procedures of setup as below:
1. Enter <Print Setup-3>, select <Encoder Setup>. It displays as
below:
2. If the Frequency Divide and frequency multiple can not be
selected, please check if FCU frequency control unit has been
installed correctly. (See CAUTION of Chapter Four 4-7page)
Status:
Printer is ready
Messa
g
e Inv / Re
v
2007 / 12 / 13 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
Ok
Exit
Message Reverse
Message Invert
On
On
ABCD
ABCD
Status:
Printer is ready
Encoder Setu
p
2007/ 12 / 3 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
Ok (F1)
Exit (F3)
Encoder Status
Frequency Divide
Off
1
Cancel
(
F2
)
(1~31)
Frequency Multiple
1 (1~31)