Saturn S Series - Page 85

INK JET PRINTER OPERATION
5-33
3. You can setup the status of encoder to be on or off if an encoder
has been installed. “On” means that the print speed is controlled
by the encoder. You can divide or multiple the frequency of the
encoder to adjust the width of message. “Message Width” is only
used to control the print quality. “Encoder is Off” shows that the
“Message Width” controls the printing speed.
4. Press <OK> to confirm the settings.
Caution :
1. The higher the “Frequency Divide” is, the wider the printing
message, and the higher the “Frequency Multiple” is, the
narrower the printing message.
2. If the “Encoder Select” is on, it only can control the print speed
under the print speed limit of the printer itself. It happens that the
width of message will be out of control (maybe wider than normal)
if it is over the speed limit available (The speed limit is according
to the “Message Width” in <Print Setup-1>). At that time, you
must decrease the product line speed or increase value of
“Message Width” or adjust the width of printing message
through adjusting “Frequency Divide/Multiple”.
3. If no encoder has been installed, you must not setup “Encoder
Select” at “On”, or else it cannot print anything because the
printer can’t receive any signal of the encoder.
Product Counter
It is used to check the quantity of the detected products and the
printed products. You can setup if it displays the quantity of printed
products in the “Message Edit Zone”. The procedures as below:
1. Enter <Print Setup-3>, select <Product Counter>, it displays as
below:
2. Enter required numbers of products need to be printed at
‘Printed numbers’, the printing will stop after reach to printed
numbers. If set as ‘0’ means print unlimited.
3. Use up/down <Direction key> to move the select box to the
“Display the Counter”, then use left/right <Adjust Key> to select
“Yes or No”. So you can setup if it displays the quantity of
printed products in the “Message Edit Zone”.
Status:
Printer is ready
Product Counte
r
2007 / 12 / 13 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
OK
Reset Printed
Products Detected
Products Printed
104756
3524
Display the Counter
No
Reset detected
Printed numbers
0